Digi-Coat Opaque White Base Coating

  • Witte coating voor op donkere ondergronden (geen textiel)
  • Inhoud: 400ml
  • Leverbaar per stuk
  • Prijs per stuk


Beschikbaarheid:

€ 27,99

Wij betalen de verzendkosten boven €250,- * Voorwaarden

Vóór 16:00 besteld, volgende werkdag in huis.

Bekijk onze producten en mogelijkheden in onze showroom, waar direct afhalen mogelijk is.

Service & Support van echte professionals.

Eigen Technische dienst.

Volg gerichte trainingen in ons professionele trainingscentrum.

Vragen:? Bel direct

0318-502897

Details
Details
Digital decorators know that sublimation inks do not print white. In order for transferred images to appear vibrant, the substrate must be white or as close to white as possible to add opacity to the transfer so that the image stands out.Unfortunately, many potential substrates that would make excellent decorated products are black or gray. For example, a piece of slate might make a lovely decorated award or photo gift, but without the proper coatings the transferred image would be very poor and commercially unacceptable.In order to prepare a dark surface for sublimation imprinting, the item must first receive a White Base layer before application of Digi Coat Clear sublimation coating. The white layer will give opacity to the image. However, since heat is used in the transfer process, the white base coat needs to be able to withstand 200 degree heat without peeling or turning yellow.Digi Coat White has been specially fabricated to work with Digi Coat Clear. It is simple to apply, may be applied to thousands of substrate materials, and will not peel or discolor under heat.Be sure to read instructions for complete details, including suggestions for optimal image and durability.Preparation Prior To Use:•Shake Can Well for 1 minute •Ensure the surface to be coated is clean dry and free from grease •If applying to polished glossy surface prime with Digi Coat Adhesion Promoter Directions for Use:•Spray at room temperature •For best results spray product approx 250mm from surface using light passes •Allow to air dry for 5 mins then apply Digi Coat Clear and cure in oven at 160C for 15-20 mins •Coverage approximately 2m2
Specificaties
Specificaties
MateriaalNee
Benodigde transferpersNee
SoortN/B
VormNee
Kies een afmetingNee
HoogteNee
Beprintbaar gedeelteNee
DikteNee
GewichtNee
Printen in spiegelbeeldJa
Temperatuur/tijdsinstellingenNee
Druk / BarNee
HulpmiddelenNee
OpmerkingNee
Beoordelen
Schrijf uw eigen review

Alleen geregistreerde gebruikers kunnen een review plaatsen. U kunt, inloggen of registreren

Brochure
Offerte Aanvragen

Vraag hier meer informatie of een offerte over dit product aan.

Uw gegevens

Bedrijfs gegevens

Contact

Uitgebreide omschrijving

* Verplichte velden