Open van Ma-Vr 8:30 - 17:30
In order to transfer an image to any product or surface using sublimation ink, that product or surface must be “sublimation receptive”.
This is not a problem when using specialty sublimation substrates. But natural and untreated surfaces like wood, metal, ceramic, leather, stone, glass and other items pose a real challenge to the digital decorator. To accept a sublimation transfer, these products must be treated with a polymer coating that when cured allows the sublimation inks to transfer onto the product.
Digi Coat Clear was created for just this challenge. Digi Coat Clear is a simple-to-use, clear base coating that allows you to create your own range of unique imprintable sublimation consumables.
Be sure to read instructions for complete details, including suggestions for optimal image and durability.
Preparation Prior To Use:
•Shake Can Well for 1 minute
•Ensure the surface to be coated is clean dry and free from grease. (For glass & ceramic prime surface with Digi Coat Adhesion Promoter)
Directions for Use:
•Spray at room temperature
•For best results spray product approx 250mm from surface using light passes
•Use multiple passes to obtain high gloss finish
•Allow to air dry for 10 mins and then cure in oven at 160C for 15-20 mins
•Coverage approximately 2m2
This is not a problem when using specialty sublimation substrates. But natural and untreated surfaces like wood, metal, ceramic, leather, stone, glass and other items pose a real challenge to the digital decorator. To accept a sublimation transfer, these products must be treated with a polymer coating that when cured allows the sublimation inks to transfer onto the product.
Digi Coat Clear was created for just this challenge. Digi Coat Clear is a simple-to-use, clear base coating that allows you to create your own range of unique imprintable sublimation consumables.
Be sure to read instructions for complete details, including suggestions for optimal image and durability.
Preparation Prior To Use:
•Shake Can Well for 1 minute
•Ensure the surface to be coated is clean dry and free from grease. (For glass & ceramic prime surface with Digi Coat Adhesion Promoter)
Directions for Use:
•Spray at room temperature
•For best results spray product approx 250mm from surface using light passes
•Use multiple passes to obtain high gloss finish
•Allow to air dry for 10 mins and then cure in oven at 160C for 15-20 mins
•Coverage approximately 2m2
| Gewicht | 1 |
| Geschikt voor Pers type | Nee |
| Clear Coating | |
| Kleur | Nee |
| Vorm | Nee |
| afmeting/maat | Nee |
| Hoogte | N/B |
| Beprintbaar gedeelte | N/B |
| Dikte | Nee |
| Gewicht | N/B |
| Printen in spiegelbeeld | N/B |
| Temperatuur/tijdsinstellingen | N/B |
| Druk / Bar | N/B |
| Hulpmiddelen | N/B |
| Opmerking | N/B |





